These numbers are your inverter's maximum input voltage and your PV array voltage. Your PV array voltage is the total voltage of all of your modules when connected in a series.
[pdf] To configure your inverter communication:click " Inverter Communication " in the menu.Refer to the steps above, under " Connect to Your Inverter.The status of your Wi-Fi connection should be ‘disconnected’. To connect to your Wi-Fi network, click “configure.Select your preferred wireless network and insert a password, then click “join.” You will now be connected to your Wi-Fi network. .
[pdf] First, turn on the battery switch, second turn on the battery switch of the single phase inverter, third turn on the solar panel switch, fourth， turn on the output, and finally turn on the load;
[pdf] All power inverters have an automatic shut off function which prevents the attached battery bank from being overly discharged. When the voltage of the batteries falls to a certain fixed level, the inverter simpl. .
The relay pictured in this article is available from Rapid, for around £6, or a wide selection of similar relays are available from a. .
One problem with many power inverters is that the automatic switch off voltage is too low – for example 10.5V or 11V. By the time the battery or battery bank gets down to this sort of level of charge, it is pretty much empty and theref. .
DISCLAIMER – mains electricity can KILL. We recommend that you talk to a qualifiedelectrician before attempting to implement any of the ideas discussed in this article.
[pdf] Maximum power point tracking (MPPT), or sometimes just power point tracking (PPT), is a technique used with variable power sources to maximize energy extraction as conditions vary. The technique is most commonly used with (PV) solar systems but can also be used with , and . The minimum input voltage should be at least 5 volts over your battery voltage OR the minimum specified in the manual. If the voltage is not high enough, the charge controller will not start.
[pdf] Disconnect the AC and DC switchesInspect your system to check if it has a disconnect switch. If not, place a reflecting or opaque surface over the solar panels.Verify that the voltage is zero by using a voltmeter or multimeter.Unplug the wires. This is simple using MC4 connectors, or you may use a socket wrench.If necessary, take out the bolts and clamping mechanisms.
[pdf] 
